• Follow us
Home > News > Content
Analysis Of The Relationship Between Drawing Speed And Drawing Force Of Drawing Machine
Jul 31, 2017

Analysis of the relationship between drawing speed and drawing force of Drawing Machine
Practice tells us that the Drawing Machine drawing speed and drawing force can not be improved at the same time, in improving the equipment operating speed, pull force will be reduced. Why is there such a state? Xiao Bian for everyone to analyze the reasons.
To say the root of the words, because the speed of the Drawing Machine at the same time, its lubrication conditions have been improved, thereby reducing the friction coefficient, so to overcome the external friction and additional shear deformation required force will also be reduced, which will make Drawing force has also been reduced. In fact, this way, or good, at least Drawing Machine safety system will improve a lot.
But the Drawing Machine drawing speed can not be too high, otherwise the device starts the moment the wire is easy to be pulled off, even if you want to use high-speed Drawing Machine, it should also pay attention to configure the appropriate speed control device and ensure that the operation Of the steady acceleration to ensure that the drawing operation can be carried out normally.
When the object has a vibration when there will be a sound, if the sound affects our rest and work it is called noise. In fact, when the industrial production or transportation, there will be noise, which is actually a kind of pollution. When we operate the wire Drawing Machine in the drawing shop, the noise he produces is very large, so that the health of the operator is also a great impact. When the gear is in motion, the tooth noise will appear, he is the largest noise source of the wire Drawing Machine, the meshing surface or the gears when they are in the assembly if there is a very wide gap then it is possible to let them in the transmission Time there is a lot of noise. We have to adjust his gear to the gap, so as to ensure that his gear lubrication.
Drawing Machine barrel in the need for heating, is the use of heating ring for heating, this way quite power, the heating process is this: first heating ring need their first fever, then the heat transfer to the Drawing Machine Barrel, then in the process of heat transfer will inevitably lose part of the heat, the waste of heat is actually a waste of energy.
In addition, because the outer surface of the heating ring is sure to come into contact with the air, then that is part of the heat will be wasted in the air, which is equal to the waste of electricity, wire Drawing Machine only heat in this part of the heating ring The loss of nearly 40 percent of electricity, in order to avoid this situation, we can use a product called electromagnetic heaters, as long as the surface of the Drawing Machine wrapped in a layer of insulation cotton, plus A layer of electromagnetic heating coil, power, the electromagnetic coil will appear electromagnetic induction, the barrel will automatically heat, due to the presence of insulation cotton temperature will not reach the air, the power is so saved, compared to Heating ring, electromagnetic heaters can save at least 30 percent more electricity, very save and cost-effective, heating speed and very ideal, is currently the best Drawing Machine partner.
The importance of the Drawing Machine in the production process does not need to be re-emphasized, but the use of the inspection before the things to be emphasized again, to further enhance the impression of people in this regard, which can reduce the failure rate of the Drawing Machine.
Check one of the contents of the ground, be sure to ensure that the wire Drawing Machine electrical equipment has a good grounding in the case can be used to prevent electric shock accident. Followed by lubricants, timely addition to help reduce the wear and tear of the Drawing Machine parts. In the course of its operation, strictly prohibit the staff free to touch the hand wheel, handle and electrical buttons, in order to avoid accidents; and the table is not allowed to place tools and other objects, so as not to affect the use of the machine.
When you start the wheel, no one can stand in front of the wheel, otherwise there may be accidents. In addition, the machine tool set by the wheel shield, belt protective cover and other safety devices must be intact, and not free to remove.