• Follow us
Home > News > Content
The Relationship Between Drawing Speed And Drawing Force Of Continuous Casting Machine Is Analyzed
Aug 18, 2017

The relationship between drawing speed and drawing force of Continuous Casting Machine is analyzed
Practice tells us that the Continuous Casting Machine drawing speed and pull force can not be improved at the same time, in improving equipment operating speed, pull force will be reduced. Why is there such a state? Xiao Bian for everyone to analyze the reasons.
To say the root cause, because the Continuous Casting Machine speed increased at the same time, its lubrication conditions have also been improved, thereby reducing the friction coefficient, so to overcome the external friction and additional shear deformation required force will also be reduced, Making the pull force is also reduced. In fact, this way, or good, at least continuous caster safety system will improve a lot.
But the Continuous Casting Machine drawing speed can not be too high, otherwise the device starts the moment the wire is easy to be pulled off, even if you want to use high-speed Continuous Casting Machine, it should also pay attention to configure the appropriate speed control device and ensure the operation The process of steady acceleration to ensure that the drawing operation can be carried out normally.
The importance of the Continuous Casting Machine in the production process does not need to be re-emphasized, but the use of the inspection before the things to be emphasized again, to further enhance people's impression of this, which can reduce the failure rate of Continuous Casting Machine.
Check one of the contents of the ground, be sure to ensure that the caster electrical equipment has a good grounding in the case of use, to prevent electric shock. Followed by lubricants, and timely additions help to reduce the wear of the caster parts. In the course of its operation, strictly prohibit the staff free to touch the hand wheel, handle and electrical buttons, in order to avoid accidents; and the table is not allowed to place tools and other objects, so as not to affect the use of the machine.
When you start the wheel, no one can stand in front of the wheel, otherwise there may be accidents. In addition, the machine tool set by the wheel shield, belt protective cover and other safety devices must be intact, and not free to remove.
 When the object has a vibration when there will be a sound, if the sound affects our rest and work it is called noise. In fact, when the industrial production or transportation, there will be noise, which is actually a kind of pollution. When we operate the caster in the drawing plant, the noise he produces is very large, so the health of the operator is also a great impact. When the gear is in motion, the tooth noise will appear, he is also the Continuous Casting Machine's largest noise source, the meshing surface or the gears they have a very wide gap in the assembly when it is possible to let them in the drive When there is a lot of noise to appear. We have to adjust his gear to the gap, so as to ensure that his gear lubrication.
Caster in the need for heating, is the use of heating ring for heating, this way quite power, the heating process is this: First, the heating ring need their first fever, then heat transfer to the Continuous Casting Machine barrel, then in the heat transfer process will inevitably be part of the loss of heat, the waste of heat is actually a waste of energy.
In addition, because the outer surface of the heating ring is sure to come into contact with the air, then that is part of the heat will be wasted in the air, which is equivalent to a waste of energy, Continuous Casting Machine only heat in this area Part of the loss of nearly 40 percent of electricity, in order to avoid this situation, we can use a product called electromagnetic heaters, as long as the surface of the caster barrel wrapped in a layer of insulation cotton, and then Plus a layer of electromagnetic heating coil, power, the electromagnetic coil will appear electromagnetic induction, the barrel will automatically heat, due to the presence of insulation cotton temperature will not spread to the air, the power is so saved, Compared to the heating ring, electromagnetic heaters can save at least 30% of the electricity, very save and cost-effective, heating speed is very good, is currently the best work of the continuous casting partner.